wrong end?

Floorguy · **Posted:** Fri Aug 28, 2009 10:24 am

Did a weave in repair with some Br-111 engineered.
Got everything prepped and now I go and pull a board out of the carton, and the ends are reverse milled?? Say what? The tongue and groove are switched on the new wood, compared to what is there now.

What a pain!!!

bw · **Posted:** Fri Aug 28, 2009 10:47 am

You were just holding the board upside down :mrgreen:

dennis · **Posted:** Fri Aug 28, 2009 10:56 am

Just turn around and face the other direction :lol:

Floorologist · **Posted:** Fri Aug 28, 2009 9:54 pm

Engineered BR-111 has a paper thin top layer.

That would be a DOUBLE pain :roll:

Flooring 101 on lace ins....Check out the wood before you prep! :wink:

Gary · **Posted:** Sat Aug 29, 2009 5:17 pm

It's my opinion manufacturers commonly change the design of their floors to require an entire floor to be replaced, instead of repaired. This is not the only reason but I am sure it is a consideration.

Floorguy · **Posted:** Sat Aug 29, 2009 8:18 pm

dennis wrote:

Just turn around and face the other direction :lol:

But then the long tongue is tongue to tongue. :shock:

dennis · **Posted:** Mon Aug 31, 2009 6:45 am

Floorguy wrote:

dennis wrote:

Just turn around and face the other direction :lol:

But then the long tongue is tongue to tongue. :shock:

Ahh but then ya gotta flip the board over too, and of course, throw on some shiny stuff.

wrong end?

Who is online