We installed a solid red oak 3/4 in thick floor the other weekend and had a question on the transitions. During installation we had our door to the bathroom open which has linolium. Unfortunately I belive the end pieces that are cut were cut a little short than need be so we have a gap to fill before we do our transition. Is there an easy way to correct this...I have to use a reducer and was looking around for a reducer with a lip on one end like a t-molding (because the floor runs perpendicular to the transition) and would need about an extra 1.5 inches than a standard 2.25 reducer can provide. Is thsi piece something that I have to custom make, or what would you recommend.

Yes, it is called a baby threshold, endcap molding, or carpet reducer.

One of those names and you will find what your looking for.

Yes, most of the time you can find a local shop to mill you a decent looking custom transition piece. If not you can go to a local hardware store, buy an oak threshold and shape it yourself. Ya might have to sand and stain it to match yours. Usually they only come in honey oak.

Seneca Millworks has what your looking for.

http://www.senecamillwork.com/images/co ... verlap.jpg

From what I understand you want an extra 1.5" over 2.25" which would mean you need 3.75" piece. You can make a threshold in less than 15 minutes. If your flooring comes in 4" width at the store (often you can buy a sample piece) then purchase one of those. Cut your piece the appropriate length. Using the table saw, cut a 45 degree bevel on the long tongue side. If your linoleum floor elevation is way too high then you need to undercut your threshold as well (best to do BEFORE you cut your bevel). Sand and stain the cut end with matching stain and then urethane it with two coats of urethane (or whatever varnish you may have on hand). Cut your floor along the door straight so that you can install your new piece flush with your floor. Glue it down and put some weight on it overnight. If you can't find a matching piece at the store then buy any 4" piece of 3/4" flooring. Sand and stain it to match as best as you can. PM me if you need more help!

-Al