Amish made hardwood

It is currently Sun Nov 24, 2024 8:45 am

All times are UTC - 5 hours




Post new topic Reply to topic  [ 12 posts ] 
Author Message
 Post subject: Stair Case Question
PostPosted: Sun Jun 12, 2011 9:28 am 
Offline
New User

Joined: Sun Jun 12, 2011 9:04 am
Posts: 9
I am in the process of replacing all my Oak floors. Around 1000 ft. My wife searched for about a year for wood type. She found Brazilian Amendoim. We purchased online for $5.50 a sq ft. I'm around 3/4 finished. The floor looks spectacular. I can not imagine doing all this work and reinstall Oak. I would like to install the Amendoim on my staircase my house is about 60 years old. Could someone point me in the right direction how to do this the correct way. I am pretty sure my treds are held in with shims from below. Cutting the ceiling below the staircase is not an option for me.

Image
Image

Thanks


Top
 Profile E-mail  
 
Amish made hardwood

 Post subject: Re: Stair Case Question
PostPosted: Tue Jun 14, 2011 9:56 pm 
Offline
Worthy Contributor

Joined: Mon Jun 13, 2011 7:36 pm
Posts: 115
Location: Spencer, TN
I'd pull one of the risers off,this is the front,or vertical part,under the step treads.Then you should be able to see how the treads are attached,and go from there.


Top
 Profile E-mail  
 
 Post subject: Re: Stair Case Question
PostPosted: Tue Jun 14, 2011 10:21 pm 
Offline
Prized Contributor
User avatar

Joined: Sun May 24, 2009 7:48 pm
Posts: 1802
Location: Las Vegas
Usually on staircases.... I'll prepare as needed, and install over existing.

_________________
Howard Chorpash
Frazier Mountain Hardwood
http://www.lasvegaswoodflooring.com


Top
 Profile E-mail  
 
 Post subject: Re: Stair Case Question
PostPosted: Tue Jun 14, 2011 11:34 pm 
Offline
Worthy Contributor

Joined: Sat Feb 13, 2010 7:37 pm
Posts: 207
Location: Great Falls, MT
We have ran into the treads that are shimmed in and we just cut the nosing and go over the existing. The ones we found that way looked to be a major PITA to remove and keep the integrity of the staircase.


Top
 Profile E-mail  
 
 Post subject: Re: Stair Case Question
PostPosted: Wed Jun 15, 2011 11:22 am 
Offline
New User

Joined: Sun Jun 12, 2011 9:04 am
Posts: 9
Thanks for the replys guys. I found some good info about stairs on this web site.

Thanks again


Top
 Profile E-mail  
 
 Post subject: Re: Stair Case Question
PostPosted: Wed Jun 15, 2011 3:29 pm 
Offline
Prized Contributor

Joined: Sat May 02, 2009 3:45 pm
Posts: 3357
Location: Tucson AZ
That wood looks awesome! Nice job!

_________________
Stephen Perrera
Top Floor Installation Co.
Tucson, Arizona
IFCII Certified Inspector
Floor Repairs and Installation in Tucson, Az
http://www.tucsonazflooring.com


Top
 Profile E-mail  
 
 Post subject: Re: Stair Case Question
PostPosted: Wed Jun 15, 2011 5:07 pm 
Offline
New User

Joined: Sun Jun 12, 2011 9:04 am
Posts: 9
Thanks, when I bought my house I gutted everything walls, ceiling , doors. My wall were plaster close to an inch thick so when I put up 1/2 dry rock I had gaps as much as 1 inch between old Oak floor and new walls. I hide gaps with molding but I hated the look for the last ten years. So I decided to rip up the old Oak floor and install simple clean molding. A lot of work but worth it.

Thanks for the compliment


Top
 Profile E-mail  
 
 Post subject: Re: Stair Case Question
PostPosted: Fri Jul 29, 2011 9:28 am 
Offline
New User

Joined: Sun Jun 12, 2011 9:04 am
Posts: 9
Question, I am doing my stair case with the 3 1/2- 3/4 solid Amendoim. I can only find the nosing in 88" lengths, I have 7 treds@32" and 8 treds@38" if I use the 88" and install nosing as one piece per tred I am looking at alot of waste. Can I piece the nosing in to avoid waste?

Thanks


Top
 Profile E-mail  
 
 Post subject: Re: Stair Case Question
PostPosted: Fri Jul 29, 2011 11:04 am 
Offline
Valued Contributor

Joined: Sun Dec 21, 2008 6:00 pm
Posts: 629
Don't do it. You have spent a lot of time and energy into your floor no point in piecing to save 2 nosings.


Top
 Profile E-mail  
 
 Post subject: Re: Stair Case Question
PostPosted: Fri Jul 29, 2011 11:56 am 
Offline
New User

Joined: Sun Jun 12, 2011 9:04 am
Posts: 9
I guess your right. Thanks for the reply


Top
 Profile E-mail  
 
 Post subject: Re: Stair Case Question
PostPosted: Tue Aug 02, 2011 7:35 pm 
Offline
New User

Joined: Tue Aug 02, 2011 2:57 pm
Posts: 5
I love those wood floors. It's such an exotic and beautiful wood. You'll have to post some pictures of how you do the stairs. The stairs are usually the hardest part if you are matching the floors.


Top
 Profile E-mail  
 
 Post subject: Re: Stair Case Question
PostPosted: Thu Aug 04, 2011 12:22 pm 
Offline
New User

Joined: Sun Jun 12, 2011 9:04 am
Posts: 9
Yes, i will

Thanks


Top
 Profile E-mail  
 
Post new topic Reply to topic  [ 12 posts ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 0 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group

phpBB SEO