Amish made hardwood

It is currently Mon Dec 23, 2024 5:39 am

All times are UTC - 5 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Sanding after staining
PostPosted: Sun Mar 17, 2013 1:04 pm 
Offline
New User

Joined: Sun Mar 17, 2013 12:49 pm
Posts: 1
Minwax instructions say do not sand after staining and before putting down clear coat. BUT when I put the second coat of stain down, I wiped it up as instructed but did not wipe it dry. A lot of what was left did not soak in like it did with the first coat and dried on top (i.e., some spots are very shiney).

I used 220 paper and a finish sander to go over the entire floor again taking off the excess stain. It is a bit lighter but if I decide I like it, do I need to do anything other than clean it before putting down clear coat?


Top
 Profile E-mail  
 

 Post subject: Re: Sanding after staining
PostPosted: Wed Mar 20, 2013 11:02 pm 
Offline
Valued Contributor

Joined: Mon Mar 14, 2011 4:36 pm
Posts: 705
Thats a redundant question..if i decide i like it? Do i have to do anything else?..umm

Let me take a stab at it,,,no?


You dont leave excess stain, particularly without wiping it even

_________________
James Hernandez
All Flortec Inc, West Milford, NJ

http://www.flortechardwood.net


Top
 Profile E-mail  
 
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 0 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group

phpBB SEO