Amish made hardwood

It is currently Sat Nov 23, 2024 4:08 pm

All times are UTC - 5 hours




Post new topic Reply to topic  [ 4 posts ] 
Author Message
 Post subject: New floor installed, I don't like one board- ok to cut out?
PostPosted: Thu Nov 30, 2017 10:30 am 
Offline
New User

Joined: Mon Dec 05, 2016 1:42 pm
Posts: 8
I had 4 inch R&Q sawn red oak installed and one board has a stripping that I don't care for. Installer says he can cut it out and glue and new piece in. Will I screw up the integrity of the floor or will it be ok? Thanks.


Top
 Profile E-mail  
 

 Post subject: Re: New floor installed, I don't like one board- ok to cut out?
PostPosted: Fri Dec 01, 2017 8:11 pm 
Offline
Prized Contributor

Joined: Tue Jun 16, 2015 12:02 am
Posts: 1754
The only thing that you may notice when a new board is installed if it was pre-finished would be that one end would be missing the slight chamfer that goes around the whole board, if it had a bevel around each board. Gluing a new board will not hurt the integrity of your floor.


Top
 Profile E-mail  
 
 Post subject: Re: New floor installed, I don't like one board- ok to cut out?
PostPosted: Sat Dec 02, 2017 9:28 am 
Offline
New User

Joined: Mon Dec 05, 2016 1:42 pm
Posts: 8
This is unfinished hardwood. So, I should be good, right? Thank you for replying.


Top
 Profile E-mail  
 
 Post subject: Re: New floor installed, I don't like one board- ok to cut out?
PostPosted: Sun Dec 03, 2017 3:06 am 
Offline
Prized Contributor

Joined: Tue Jun 16, 2015 12:02 am
Posts: 1754
Replace the "bad" board before sanding, or before the final coat of finish is spread over the whole floor.


Top
 Profile E-mail  
 
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group

phpBB SEO